10mm Hollow Aluminum Rod Bending Machine | U Handles
A benchtop rotary bender forms U-handles from 10 mm hollow aluminum rod - the wrap-around die keeps the tube round and the coated surface clean.
Key Specifications
- Materials
- 10 mm hollow aluminum round rod
Key Features
- Bends 10 mm hollow aluminum rod into U-handles
- Wrap-around die keeps the tube section round
- Coated surface stays clean and unmarked
- Both ends formed in one quick setup
How Are 10 mm Hollow Aluminum Rod Handles Bent Without Flattening?
Short answer: On a rotary wrap-around die that supports the tube through the bend. This video shows 10 mm hollow aluminum rods being formed into U pull handles on a benchtop bender - each end sweeps around the bend pin while the clamp holds the tube firmly, so the section stays round and the coated surface comes out clean.
What the Video Demonstrates
| Stage | Equipment | Result |
|---|---|---|
| Stage | Bundles of hollow aluminum rods | Constant supply of blanks |
| Clamp | Red clamp block with tube groove | Tube held without crushing |
| Sweep | Rotary wrap-around bend pin | Round bend, clean coated surface |
| Repeat | Index and form the second leg | Identical U-handles in rows |
Key Applications
- Cabinet, wardrobe and door U-pull handles
- Coated and anodized hardware needing mark-free bends
- Appliance and enclosure grip handles
- High-volume handle workshops
Rotary Bending vs. Press Bending for Hollow Rod
| Criterion | Press bending | Rotary wrap-around bending |
|---|---|---|
| Hollow section | Flattens or wrinkles | Stays round |
| Coated surface | Marks and scuffs | Clean finish retained |
| Both ends per setup | Re-clamp needed | Index and sweep |
| Batch consistency | Operator dependent | Identical rows |
FAQ
What stock is demonstrated? 10 mm hollow aluminum round rod, shown as straight bundles and as finished U-handles in the video.
Will bending damage the coated finish? No - the clamp grips away from the visible face and the wrap-around action keeps contact smooth, so the coating stays clean.
Can the same station bend solid rod? Yes - swap the clamp groove and bend die for solid stock of the same diameter; the drive handles both.