Aluminum Handle Tapping Machine | High-Speed Twin Taps
A fast twin-spindle tapping machine threads the mounting ends of bent aluminum ring handles in one placement - clean threads, parts ready to assemble.
Key Specifications
- Materials
- Bent flat aluminum ring handle parts
Key Features
- Threads both handle ends in a single placement
- Twin vertical taps belt-driven for high speed
- Simple push-in fixture positions each part
- Clean, full-depth threads in aluminum ends
How Are Aluminum Handle Ends Tapped in One Cycle?
Short answer: With twin vertical taps that hit both ends at once. This video shows a fast tapping machine threading the mounting holes of bent aluminum ring handles: the operator pushes the part into the fixture, two belt-driven spindles tap both end bosses in a single cycle, and the finished handles line up ready for assembly.
What the Video Demonstrates
| Stage | Equipment | Result |
|---|---|---|
| Place | Push-in fixture on the table | Both end bosses under the taps |
| Tap | Twin vertical belt-driven spindles | Two clean threads in one cycle |
| Check | Finished ends shown in hand | Full-depth, ready-to-screw holes |
| Batch | Row of ring handles on the table | High output verified |
Key Applications
- Rectangular ring pull handles with screwed end covers
- Aluminum handle production lines after bending
- High-volume hardware workshops replacing single taps
- Any two-hole pattern that must be threaded per cycle
Twin-Spindle One-Cycle vs. Single-Tap Tapping
| Criterion | Single tap | Twin-spindle machine |
|---|---|---|
| Holes per cycle | One | Two at once |
| Re-positioning | Every hole | None |
| Cycle time | Multi-pass | One push and tap |
| Output per operator | Low | Doubled or better |
FAQ
Which handle parts can this machine tap? Bent flat aluminum ring handles with round end bosses as shown; fixtures and tap spacing are matched to your handle geometry.
What thread sizes does it cut? The heads accept standard machine-screw taps - send your thread spec and the machine is set up with matching taps and drill sizes.
Is it suitable for fully automatic production? The tapping cycle itself is automatic once the part is placed; multi-station and feed-through versions can be built for higher volumes.