9mm Stainless Round Rod Handle Bending Machine
A benchtop rotary bender forms 9 mm solid stainless round rod into U and L handle shapes - straight rods in, clean bent pulls out, batch after batch.
Key Specifications
- Materials
- 9 mm solid stainless steel round rod
Key Features
- Bends 9 mm solid stainless rod into handle shapes
- Wrap-around bend pin keeps the rod surface clean
- Red clamp block holds the rod at each corner
- Straight rods staged in bundles for fast cycles
How Is 9 mm Stainless Round Rod Bent into Handle Shapes?
Short answer: One corner at a time around a rotary bend pin. This video shows bundles of 9 mm solid stainless round rod fed into a benchtop bender - the operator clamps the rod at the red block, sweeps each corner, and crisp U and L handle shapes come off identical, row after row, with calipers confirming the leg lengths.
What the Video Demonstrates
| Stage | Equipment | Result |
|---|---|---|
| Stage | Rod bundles laid beside the station | Constant supply of blanks |
| Clamp | Red block over the bend line | Rod held at the correct position |
| Sweep | Rotary wrap-around bend pin | Clean corner, no surface marks |
| Check | Caliper on the finished part | Consistent leg lengths |
Key Applications
- Stainless rod pull and door handle shapes
- Cabinet, enclosure and equipment hardware
- Display racks, guards and bracket frames
- Hardware shops replacing hand bending
Rotary Rod Bending vs. Press Bending
| Criterion | Press bending | Rotary wrap-around bending |
|---|---|---|
| Multi-corner parts | Re-clamp each hit | Index along one die |
| Stainless surface | Scoring common | Clean, no marks |
| Corner consistency | Operator dependent | Identical rows of parts |
| Setup cost | Heavy tooling | Bolt-on clamp and pin |
FAQ
What stock is demonstrated? 9 mm solid stainless steel round rod, as captioned in the video; dies are matched to other diameters on request.
How many bends make one handle? The U and L shapes shown need one or two corner bends - each is a quick clamp, sweep and index on the same setup.
Can the station run other rod sizes? Yes - change the clamp groove and bend pin and the same benchtop machine produces different diameters and handle profiles.