9mm Solid Stainless Round Bar Bending Machine
Watch a rotary die bending machine form 9 mm solid stainless steel round bar into threaded-end handle parts in one quick stroke - fast, repeatable rod bending.
Key Specifications
- Materials
- 9 mm solid stainless steel round bar
Key Features
- Forms 9 mm solid stainless rod in one rotary stroke
- Wrap-around die keeps the stainless surface clean
- Tight, repeatable bend angles with positive stops
- Handles threaded-stud end parts without rework
How Is 9 mm Solid Stainless Round Bar Bent into Handle Parts?
Short answer: On a rotary die bending machine. This video shows 9 mm solid stainless steel round bar fed into a benchtop bender and wrapped around the die in a single stroke, producing handle parts with clean bends and fitted threaded end studs.
What the Video Demonstrates
| Stage | Equipment | Result |
|---|---|---|
| Feed | Manual rod insertion against stop | Correct bend position every time |
| Clamp | Red clamp block on rotary table | Bar locked without marring |
| Form | Rotary wrap-around die | Crisp bends in one stroke |
| Inspect | Finished part in hand | Clean stainless handle with threaded ends |
Key Applications
- Stainless steel pull and crank handles
- Door, cabinet and enclosure hardware
- Threaded-end handle blanks for further assembly
- Hardware shops replacing hand bending with a benchtop bender
Rotary Die Bending vs. Hand Bending for Solid Rod
| Criterion | Hand bending | Rotary die bending |
|---|---|---|
| Bend angle control | Guesswork | Positive stop at set angle |
| Surface quality | Tool marks likely | Clean stainless finish |
| Cycle time | Slow, fatiguing | One quick stroke |
| Part consistency | Varies per operator | Repeatable batch output |
FAQ
What rod sizes can this bending machine handle? It is shown forming 9 mm solid stainless round bar; dies can be matched to other diameters on request.
Can the machine bend mild steel or brass as well? Yes - with the correct die set, carbon steel, brass and aluminum rod in a comparable size range bend on the same station.
Are the threaded end studs added by the machine? No. The video shows end studs fitted on the part; the bender forms the handle geometry around them.