12mm Stainless Round Rod 90-Degree L-Bend Rotary Bender
A rotary wrap die bends 12 mm solid stainless round rod into 90-degree L-elbow handles, red clamp blocks indexing each rod so every leg and radius matches.
Key Specifications
- Materials
- 12 mm stainless steel solid round rod
Key Features
- Bends 12 mm solid stainless round rod to a clean 90-degree elbow
- Rotary wrap die holds the rod for a tight, even radius
- Red clamp blocks index each rod for matching leg lengths
- Manual-feed single-station cycle suits short handles
How Is a 12 mm Stainless Round Rod Bent to a Clean 90-Degree Elbow?
Short answer: On a rotary wrap die with shaped clamp blocks. This video shows 12 mm solid stainless round rod being bent to a right-angle L-elbow - the rod wraps around the die pin while the blocks support it, so the bend comes out with a tight, even radius and the round section stays round with no flattening or marks.
What the Video Demonstrates
| Stage | Equipment | Result |
|---|---|---|
| Feed | Manual insertion into red clamp blocks | Rod indexed at the bend line |
| Form | Rotary wrap die, single station | Clean 90-degree elbow |
| Repeat | Leg length checked against stock | Matching L-bend geometry |
| Batch | Bent rods collected in a box | Identical elbows part after part |
Key Applications
- Stainless L-bend rod handles and elbows
- Right-angle rod links and cranks
- Small-batch rod forming on a rotary table
- Replacing press bending that flattens round rod
Rotary Wrap Bending vs. Press Bending Round Rod
| Criterion | Press bending | Rotary wrap bending |
|---|---|---|
| Section at bend | Flattens, ovaling | Round held as shown |
| Bend radius | Springback, uneven | Tight, consistent 90-degree |
| Rod support | Open span | Clamped along the bend |
| Batch uniformity | Operator dependent | Clamp blocks repeat the position |
FAQ
What stock is shown being bent in the video? 12 mm solid stainless steel round rod, formed into a 90-degree L-elbow handle.
Does the bend flatten or mark the rod? No - the wrap die and shaped clamp blocks support the section through the stroke, and the video shows the rod staying round and clean on every bend.
Can the machine run other rod sizes and bend angles? Yes - die pins and clamp blocks are matched to your rod diameter and target angle on request.